Synthesis and Evaluation of Alum Crystals from Waste Aluminum Foils in Turbid Water Treatment
DOI:
https://doi.org/10.54536/jir.v1i1.1528Keywords:
Aluminium Foil, Alum Crystals, Coagulant, Water Treatment and TurbidityAbstract
The disposal of waste aluminum foil is a significant environmental concern due to its non-biodegradable nature and potential to contaminate the surrounding ecosystem. In this study, we synthesized alum crystals from waste aluminum foil and evaluated their potential as an effective adsorbent for water treatment. The synthesis process involved the reaction of crushed aluminum foil with sulfuric acid and sodium hydroxide to form aluminum hydroxide, which was then converted to alum crystals through a precipitation reaction. Chemical tests were conducted to confirm the presence of different ions in alum solution and solid alum crystals. The tests showed the presence of sulfate ions, potassium ions, and aluminum ions. Additionally, the study examined the effect of different dosages (10 to 100 mg/l) of alum on turbidity removal (triplicate) in water, where increasing the alum dosage led to an increase in turbidity removal, but beyond a certain point, the marginal increase in turbidity removal diminished. A dosage of around 40–50 mg/L was established as optimal for achieving a balance between effective turbidity removal and cost-effective use of alum, using a quadratic relationship to model a non-linear relationship between turbidity removal and alum dosage. This study demonstrates the potential of waste aluminum foil as a valuable resource for the synthesis of alum crystals, which can be used as an effective adsorbent for water treatment. Using waste materials for the synthesis of value-added products not only helps reduce environmental pollution but also contributes to the development of sustainable technologies. The results of this study have significant implications for the development of cost-effective and environmentally sustainable solutions for water treatment.
References
Adejumo, A.L. et al. (2016). Synthesis, characterization and efficiency of alum produced from waste aluminum cans for wastewater treatment. Journal of Engineering and Applied Sciences, 8–13. https://doi.org/10.5455/jeas.2016110102.
Åhlgren, K. and Bäckström, M. (2021). Environmental impact of Alum Shale Mining and oil and uranium production in KVARNTORP, Sweden, based on Historical Archives and Environmental Monitoring Data. Oil Shale, 38(4), 338. https://doi.org/10.3176/oil.2021.4.04.
Ahmed, M. (2019). Characterization of the Youssoufia-Morocco-MineFluoride-Contaminated Water and Their Detrimental Effects on Human Health. In Environmental Chemistry and Recent Pollution Control Approaches (p. 3). IntechOpen.
Cinque, K., Stevens, M. A., Roser, D. J., Ashbolt, N. J., & Leeming, R. (2004). Assessing the health implications of turbidity and suspended particles in protected catchments. Water Science and Technology, 50(1), 205–210. https://doi.org/10.2166/wst.2004.0055
Dayarathne, H.N.P. et al. (2021). Removal of natural organic matter from source water: Review on coagulants, dual coagulation, alternative coagulants, and Mechanisms. Journal of Water Process Engineering, 40, 101820. https://doi.org/10.1016/j.jwpe.2020.101820.
Devesa-Rey, R. et al. (2011). Evaluation of non-conventional coagulants to remove turbidity from water. Water, Air, & Soil Pollution, 223(2), 591–598. https://doi.org/10.1007/s11270-011-0884-8.
Ding, X. et al. (2018). Lignosulfonate treating bauxite residue dust pollution: Enhancement of mechanical properties and wind erosion behavio. Water, Air, & Soil Pollution, 229(7). https://doi.org/10.1007/s11270-018-3876-0.
Jo, J.-Y. et al. (2021). Pelletized adsorbent of alum sludge and bentonite for removal of arsenic. Environmental Pollution, 277, 116747. https://doi.org/10.1016/j.envpol.2021.116747.
Jung, K.-W. and Ahn, K.-H. (2015). Dual purpose recovered coagulant from drinking water treatment residuals for adjustment of initial ph and coagulation aid in electrocoagulation process. Environmental Technology, 37(13), 1605–1617. https://doi.org/10.1080/09593330.2015.1122096.
Klug, H. P., & Alexander, L. (1940). Crystal-chemical studies of the alums. I. Solid Solutions of potassium aluminum alum and ammonium aluminum alum. Journal of the American Chemical Society, 62(6), 1492–1493. https://doi.org/10.1021/ja01863a046
Li, F., & Yuan, G. (2005). Low temperature catalytic conversion of methane to methanol by barium sulfate nanotubes supporting sulfates: pt(so4)2, HGSO4, CE(SO4)2 and pb(so4)2. Chemical Communications, 17, 2238. https://doi.org/10.1039/b500147a
Maderich, V., & Bezhenar, R. (2021, March). Modelling study of the potential release of contaminated water from storage tanks at the Fukushima Dai-ichi NPP into marine environment. In EGU General Assembly Conference Abstracts (pp. EGU21-10690). https://doi.org/10.5194/egusphere-egu21-10690.
Menezes, J.C.C.C. et al. (2016). Effect of pyrite concentration on the quality of ferric sulfate coagulants obtained by leaching from coal tailings. Minerals & Metallurgical Processing, 33(2), 77–81. Available at: https://doi.org/10.19150/mmp.6624.
Moshammer, H. (2010). Communicating health impact of air pollution. Air Pollution [Preprint]. https://doi.org/10.5772/10042.
Mousavi, S. M., Akbari, H., Ashrafi, S. D., & Kamani, H. (2022). Comparison of natural extract as a clean coagulant with alum and natural extract-alum hybrid coagulant for removal of water turbidity. DESALINATION AND WATER TREATMENT, 258, 197–206. https://doi.org/10.5004/dwt.2022.28418
Naik, R.K. et al. (2019). Microplastics in ballast water as an emerging source and vector for harmful chemicals, antibiotics, metals, bacterial pathogens and hab species: A potential risk to the marine environment and human health. Marine Pollution Bulletin, 149, 110525. https://doi.org/10.1016/j.marpolbul.2019.110525.
Nowacka, A., Włodarczyk-Makuła, M. and Macherzyński, B. (2014. Comparison of effectiveness of coagulation with aluminum sulfate and pre-hydrolyzed aluminum coagulants. Desalination and Water Treatment, 52(19-21), 3843–3851. https://doi.org/10.1080/19443994.2014.888129.
Olukowi, O. et al. (2022). Performance improvement and mechanism of PAC/PDMDAAC coagulant via enhanced coagulation coupled with sand filtration in the treatment of Surface Water. SSRN Electronic Journal [Preprint]. https://doi.org/10.2139/ssrn.4130059.
Qadafi, M. et al. (2023). Characteristics and treatment methods for peat water as clean water sources: A mini review. Water Cycle, 4, 60–69. https://doi.org/10.1016/j.watcyc.2023.02.005.
Rahama, M.S., Mashi, A. L. and Muhammad, A. S. (2020). Comparative studies between alum synthesized from aluminum cans and natural coagulant synthesized from Watermelon Seed. Studia Universitatis Babe-Bolyai Chemia, 65(4), 125–133. https://doi.org/10.24193/subbchem.2020.4.10.
Ramakrishnan, S. and Jayaraman, A. (2022). Pesticide contaminated drinking water and health effects on pregnant women and children. Research Anthology on Advancements in Women’s Health and Reproductive Rights, 682–696. https://doi.org/10.4018/978-1-6684-6299-7.ch035.
Roswinabila, C. A. (2023). The effectiveness of ultraviolet based methods versus other novel methods in the disinfection of escherichia coli found in drinking water: A systematic review. Research Review, 05(12). https://doi.org/10.52845/cmro/2022/5-12-5.
Sanga, P., Iradukunda, Y. and Munyemana, J. (2018) Recycling of Alum from Water Treatment Residue and Reuse It as a Flocculating Agent for Raw Water Treatment. Journal of Geoscience and Environment Protection, 6, 216-226. https://doi.org/10.4236/gep.2018.612018.
Suzuki, Y. et al. (2022). Application of coagulation and foam concentration method to quantify waterborne pathogens in river water samples. Water, 14(22), 3642. https://doi.org/10.3390/w14223642.
Technical, A. A. C. C. (2009). Melting point--capillary method. AACC International Approved Methods. https://doi.org/10.1094/aaccintmethod-58-40.01
Ugwekar, D.R.P. (2012). Potash alum from waste aluminum cans and medicinal foil. IOSR Journal of Engineering, 02(07), 62–64. https://doi.org/10.9790/3021-02716264.
Verma, A., Corbin, D. and Shiflett, M. (2021). Extraction of aluminum and iron from bauxite: A unique closed-loop ore refining process utilizing oxalate chemistry.https://doi.org/10.22541/au.162362374.48957826/v1.
Wu, Z. et al. (2020). High-poly-aluminum chloride sulfate coagulants and their coagulation performances for removal of humic acid. RSC Advances, 10(12), pp. 7155–7162. https://doi.org/10.1039/c9ra10189f.
Xu, Y., Chen, T., Cui, F., & Shi, W. (2016). Effect of reused alum-humic-flocs on coagulation performance and FLOC characteristics formed by aluminum salt coagulants in humic-acid water. Chemical Engineering Journal, 287, 225–232. https://doi.org/10.1016/j.cej.2015.11.017
Yun Ming, L. et al. (2015). Synthesis of alum from discarded aluminum beverage cans. Key Engineering Materials, 660, 284–288. https://doi.org/10.4028/www.scientific.net/kem.660.284.
Zheng, Y. et al. (2016). Transport mechanisms of soil-bound mercury in the erosion process during rainfall-runoff events. Environmental Pollution, 215, 10–17. https://doi.org/10.1016/j.envpol.2016.04.101.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2023 Olabimtan Olabode. H, Akinlotan Oluyinka. O, Joyce Omohu, Ukpong Martins. K, Yekeen Bayo H
This work is licensed under a Creative Commons Attribution 4.0 International License.
